Perle Systems RIO 5500036-17 - Manual (Page 170)

RIO Remote I/O System User Guide
Installing Remote Terminal Adaptors (RTAs)
Page 170
Chapter 2 Installing hardware and software
Mounting the RRC16
You can mount the RRC16 unit in a number of ways. See the following for details;
• Mounting on a flat surface on page 170
• Rack mounting on page 171
• Rack mounting on page 171
Mounting on a flat
surface To mount an RRC16 on a flat surface proceed as follows;
1. Take the RRC16 and fix one of the self adhesive rubber mounting feet provided with the
unit on each corner of the underside as shown in the next picture.
2. Install and cable up the unit using the procedure described in RRC16 Remote
Concentrator on page 168 .
Warning
When using multiple RRC16s, first fit the rubber mounting feet
supplied with each unit (see
page 170 ), and do not stack the
units more than four high as this may cause overheating.
Mount feet on
corners of underside