Removing rio, Drivers and utilities from your system – Perle Systems RIO 5500036-17 User Manual
Page 42
Advertising
RIO Remote I/O System User Guide
Installing RIO under Solaris
Page 42
Chapter 2 Installing hardware and software
Removing RIO drivers and utilities from your system
To remove the RIO device drivers and utilities for the Solaris operating system, proceed as
follows;
1. Login to your system as super user and begin a terminal session.
2. At the command prompt, type
pkgrm rio
and press the
Enter
key.
The following question is displayed:
3. At the question prompt, type
y
and press the
Enter
key.
A further confirmation is displayed.
4. At the question prompt, type
y
and press the
Enter
key to remove the software package.
The messages shown in the next picture are now displayed and RIO driver and utility
software removed.
Advertising