Perle Systems RIO 5500036-17 - Manual (Page 246)

RIO Remote I/O System User Guide
Command line utilities
Page 246
Chapter 5 RIO command line utilities
Command line utilities
This section includes the following;
• rioisacfg utility on page 246
• rioconfig utility on page 247
• RIO system commands under Solaris/Linux/LynxOS on page 248
rioisacfg utility
Operating systems Available under: Solaris.
The rioisacfg utility allows you to define addresses and IRQ levels for RIO host
cards you add to the system. The command syntax for this utility is as follows;
rioisacfg [ -n <name>] [ -m <addr>] [ -i <irq>] [ -p ] [ -a <ioaddr>] [ -d <name>]
Where:
Some typical example commands are shown below;
For information on using the rioisacfg utility to assign host card addresses and IRQ levels,
see Assigning ISA host card addresses and IRQ levels on page 41 in Chapter 2
Installing hardware and software .
Command Description
-n <name> Specifies the host card name
-m <addr> Specifies host card memory address
-i <irq> Specifies host card interrupt level
-p Toggles the state of polling
-a <ioaddr> Specifies the host card i/o address
-d <name> Deletes the named host card entry
-l Lists the current configuration
Example command Description
/etc/rioisacfg -n ISA1 -m 0xD0000 -i 9 Set host card
parameters.
rioisacfg -p Sets polling.
rioisacfg -d ISA1 Deletes an ISA card.