Perle Systems RIO 5500036-17 - Manual (Page 165)

RIO Remote I/O System User Guide
Installing Remote Terminal Adaptors (RTAs)
Page 165
Chapter 2 Installing hardware and software
RTA16 16 port Remote Terminal Adaptors
Installation procedure
To install an RTA16 proceed as follows;
1. Connect the link cables from the host card or other RTA to your RTA16 into the link
socket of your choice.
Warning
When using multiple RTA16s, do not stack the units more than
four high as this may cause overheating.
Power
Link ports A to D
(Mini DIN)
Note that Link
retention bracket
not shown
Rear view of RTA16 using
DB25 ports
Rear view of RTA16
using RJ45 ports
Power
Link ports A to D
(Mini DIN)
Note that Link
retention bracket
not shown
Connect peripherals here
Hint
To prevent accidental removal of link cables, fit the link retention
bracket supplied with the unit as shown in the next picture.