Perle Systems RIO 5500036-17 - Manual (Page 276)

RIO Remote I/O System User Guide
Solaris troubleshooting
Page 276
Troubleshooting guide
This section includes the following;
• Host cards on page 276
• Remote Terminal Adaptors (RTAs) on page 277
• Ports on page 278 .
Host cards
Problem Action required
Device driver does not start after installation 1. Ensure PCI host cards have been installed.
See page 156 .
2. Ensure ISA card settings have been specified.
See page 158 .
Host card not recognised by system 1. Check physical installation of PCI and ISA
host cards, and ensure board correctly seated
in bus slot. See
page 156 and page 158 .
2. Check ISA board memory settings, and
ensure they match the setting specified by the
rioisacfg file during installation. See page
158 .
3. Check the interrupt setting on ISA host cards,
to see if the interrupt specified by the
rioisacfg file during installation is available for
ISA use. See page 41 .
Note that on most systems it is a
requirement that ISA interrupts are
reserved in either the BIOS setup, or
system configuration program.