Printronix ThermaLine Series - Manual (Page 123)

4–79 Commands
Paper
Purpose Controls the printer cutter, print intensity, label sensor, page orientation
(portrait/landscape), and print speed.
Mode NORMAL, EXECUTE
NOTE: More than one option may follow the paper command.
Format (cc)PAPER [;option[ #]]
NOTE: Not all options may be available with your printer. Consult your printer’s
Setup Guide to determine which options are available. If an option is not
available, the emulation will ignore the corresponding command.
(cc) The Special Function Control Character.
PAPER The PAPER command; enter PAPER. Refer to
Table 4–3, on page 4–80.
CUT # Sets the printer to cut a label after a specified number
of labels. Enter CUT, a space, and a number in the
range of 1 to 100 (1 implies no cutting).
EJECT Prints all labels that are in the buffer. Enter EJECT.
INTENSITY # Specifies the darkness of the dots. Enter INTENSITY,
a space, and a number in the range of –10 to +10.
LABELS # Specifies the label sensor. Enter LABELS, then a
space, then a number: 0 = disable; 1 = Reflective
Sensor; 2 = Transmissive Sensor.
LANDSCAPE Identifies the selected paper cassette in the landscape
orientation. Enter LANDSCAPE. See ROTATE.
PORTRAIT Identifies the selected paper cassette in the portrait
(default) orientation. Enter PORTRAIT. See
ROTATE.