Printronix ThermaLine Series - Manual (Page 43)

PTX_Setup 3–5
DEL;“<filename>”
Deletes the given file enclosed in double quotation marks from the printer
external memory. If the file is not found, no action is taken.
FONT;“[drive]<font number>”
Allows downloading of HP LaserJet II bitmap fonts into a memory module.
The syntax is as follows:
DISK_IO–FONT;“[Drive:]<font number>”
<Font Data>
FONT_END
Note that when using the FONT command, it should be the only command
on the line (i.e., multiple DISK_IO commands should not be used along
with the FONT command on the same line). The <Font Data> follows
immediately after the command.
All data following the FONT command will be interpreted and stored as a
font on the proper module. The font will be stored on the drive specified in
the command, if it was included; otherwise, it will use the default drive. The
font number can be in the range of 1–99. The same font number should be
used when the font is activated (using the font command).
ENGINE
The following list contains the valid parameter/values for controlling the
print engine and setting the Paper Control menu options. Some parameters or
values are not available or do not apply to all engines. (Consult the engine
manual for specific ENGINE options.)
If a valid parameter is given but does not apply to the current engine, then it
is ignored. If a valid value is outside the available range for the current
engine, then the option will be set with the closest available value for that
engine.
ALM_WIDE;#
Defines the Automatic Label Mapping (ALM) wide–web width in 1/1000ths
of an inch increments from 0–65535.