Printronix ThermaLine Series - Manual (Page 209)

5–71 Bar Codes
FIM
The FIM (Facing Identification Mark) bar code structure is shown in
Figure 5–14 and Figure 5–15 and described on the following pages. The left
boundary must begin 3 inches from the right edge of the mail piece. The
right–most bar must be 2 inches
±
1/8–inch from the right edge of the mail
piece. Bars must be 5/8–inch
±
1/8–inch tall; the top of the bars must be no
lower than 1/8–inch from the top edge of the mail piece (and may touch the
top edge of the mail piece). The bar code baseline must be within 1/8–inch
from the bottom edge of the clear zone.
Return Address Area
5/8”
1–1/4”
(Optional Line)
(Top Line)
(Optional Line)
(Line Above Last)
(Last Line)
NON–ADDRESS DATA
NAME OF RECIPIENT
INFORMATION/ATTENTION LINE
DELIVERY ADDRESS
POST OFFICE STATE ZIP
SR, SC
POSITION
1–3/4”
Clear
3”
1/8”
2”– 1–7/8” NOTE: Illustration is not to scale
Zone
Figure 5–14. FIM Structure