Printronix ThermaLine Series - Manual (Page 20)

1–8 Introduction
Table 1–1. Normal Mode Commands
Command Mnemonic Description Page #
Compressed Print DENSITY Defines the horizontal print density in characters per inch (cpi). 4–33
Configuration CONFIG Reconfigures IGP/PGL parameters. 4–34
Create CREATE Places the IGP/PGL in the Create Form mode where all the Create Form mode
commands are available to design form elements. 4–39
Create Logo LOGO Places the IGP/PGL in the Create Logo mode, where logos can be defined using
the appropriate dot placements. 4–74
Delete Form DELETE FORM Deletes a selected form name from the directory and IGP/PGL memory. 4–41
Delete Logo DELETE LOGO Deletes a selected logo name from the directory and IGP/PGL memory. 4–42
Directory DIRECTORY Provides a list of all defined forms and logos, logo assignments to forms, and
memory usage and availability. 4–43
Execute EXECUTE Executes a previously created form. 4–49
Expanded Print EXPAND Expands fonts vertically and horizontally. 4–60
Font FONT Selects a specific typeface, bold, slant (italic) factor, and symbol set. 4–61
Ignore Sequence
On/Off IGON
IGOFF Enables the IGP/PGL to ignore all characters after the Ignore Sequence On
command is sent until the Ignore Sequence Off command is sent. See Note on
Page 1–11. 4–65
Line Spacing,
Vertical LPI Defines the lines per inch (lpi) printing format. 4–66
Listen LISTEN Removes IGP/PGL from the quiet state and enables IGP/PGL operation. 4–71
Multinational
Character Set USET
ISET Use a multinational character set or create a custom user–defined character set. Chapt. 6
Normal Mode NORMAL Places the IGP/PGL in the Normal mode, where it does not change the data
stream but awaits the SFCC followed by an IGP/PGL command. 4–77
Paper PAPER Selects features such as paper cutter, print intensity, label sensor, page
orientation (portrait/landscape), and print speed. 4–79
Print File PRINT Prints a file from external memory 4–83
Quiet QUIET IGP/PGL operation is disabled until a Listen command is received. Any data
sent to the LinePrinter Plus Emulation is unaffected by IGP/PGL commands. 4–84
Reset RESET Deletes all forms and logos from the IGP/PGL memory. 4–85
Select Format
On/Off SFON
SFOFF Ignores all host–generated paper movement commands. See Note on Page
1–11. 4–90
Set Up SETUP Automatically executes and loads the IGP/PGL commands into the printer at
power–up or after a RESET command is sent. 3–2
Printer Mode PMODE Included only for compatibility; not recommended for use. N/A
Scaling Mode SMODE Included only for compatibility; not recommended for use. N/A