Promise Technology Network Device EX8654 - Manual (Page 193)

179
Chapter 6: Management with the CLI
• Opening the CLI on Windows (below)
• Opening the CLI on Linux, FreeBSD, and VMware (page 180)
• Table of Supported Commands (page 181)
• Notes and Conventions (page 183)
• List of Supported Commands (page 184)
SuperTrak EX Controller’s Command Line Interface (CLI) provides rapid setup of
disk arrays and logical drives. You can also manage your SuperTrak system
using the CLI. However, ongoing management is much easier with the
SuperBuild utility or WebPAM PRO.
Opening the CLI on Windows
To open the CLI, click the CLI icon on the desktop (right), or:
1.
Go to Start > Run and click the Browse button.
2. Navigate to the C:\Program Files\WebPAMPRO\Agent\bin folder.
3. Click cliib.exe file then click the Open button.
4. Click the OK button in the Run dialog box.
The CLI window opens.