Promise Technology Network Device EX8654 - Manual (Page 225)

Chapter 6: Management with the CLI
211
Examples
rc
rc -a start -l3 -n -p
rc -a start -l3
rc -a stop -l2
rb
Usage
rb [-a <action>] [-d <DaId>] [-s <SeqNo>]
rb -a start -d <DaId> -s <SeqNo> -p <PdId>
rb -a stop -d <DaId> -s <SeqNo>
rb -a pause -d <DaId> -s <SeqNo>
rb -a resume -d <DaId> -s <SeqNo>
Summary
The rb command starts, stops, pauses, and resumes a Rebuild and monitors the
progress of a running Rebuild.
Options
-a <action> Specifies action to perform.
list (Default) Displays the running and paused Rebuilds and
their status.
start Starts a manual Rebuild.
stop Stops a Rebuild.
pause Pauses a Rebuild.
resume Resumes a paused Rebuild.
-d <DA ID> Specifies which disk array on which to perform the
Rebuild.
-s <sequence Num> Specifies the sequence number of the failed physical
drive. The source drive of the Rebuild.
-p <PD ID> Specifies the ID of the replacement physical drive. The
target drive of the Rebuild.
Examples
rb
rb -a start -d0 -s2 -p10
rb -a stop -d0 -s2