Panasonic AJ-HPX2000 - Manual (Page 105)

105 Preparation Mounting the Camera on a Tripod
P
repa
ra
ti
o
n
1
Connect the audio device to the AUDIO IN jack with
the XLR cable.
2
Set the AUDIO IN switch to [REAR] for the channel to
which the XLR cable is connected.
3
Set the LINE/MIC/+48V selector switch on the rear
panel to [LINE].
When mounting the camera on a tripod, use the tripod adapter supplied with the camera.
1
Mount the tripod adapter on the tripod.
‹ Note
Select an appropriate hole in the adapter, taking into
account the center of gravity of the camera and tripod
adapter combined.
Also, make sure that the diameter of the selected hole
matches the diameter of the pan head screw.
2
Mount the camera on the tripod adapter.
Slide the camera forward along the grooves until you
hear a “click”.
While holding the red lever down, move the black lever in
the direction of the arrow, and slide the camera backward
to remove it.
‹ Note
If the tripod adapter pin does not return to its original
position after the camera has been removed, hold the red
lever down and move the black lever in the direction of the
arrow again, in order to return the pin to its original
position.
Please note that the camera cannot be mounted if the pin
remains in the center.
When Using Audio Devices
LINE/MIC/+48V
Selector Switch
AUDIO IN Jack
AUDIO IN
Switch
Mounting the Camera on a Tripod
Pan head
Tripod Adapter
Removing the Camera from the Tripod Adapter
Tripod Adapter
Red Lever Black Lever
AJ-HPX2000P(VQT1D27-1)E.book 105 ページ ２００７年７月３０日 月曜日 午後１時３１分