Panasonic AJ-HPX2000 - Manual (Page 85)

85 Adjustments and Settings for Recording : Handling data
A
d
ju
stm
ents and S
e
tti
ngs f
o
r
Rec
o
rdi
n
g
4
To format the SD memory card, turn the JOG dial
button to move the cursor to YES. Then, press the dial
button.
When the SD memory card has been formatted, the
following message appears:
The card will not be formatted if the following message
appears when the JOG dial button is pressed:
5
To exit the menu, press the MENU button.
The settings menu disappears and the status of the
unit is indicated at the top and bottom of the
viewfinder screen.
‹ Note
If an SD memory card is inserted or removed with the
<SD CARD READ/WRITE> screen open, the data
title cannot be edited.
Move the cursor to the option TITLE READ and press
the JOG dial button.
Edit the data title.
1
Navigate the menu to the <SD CARD READ/WRITE>
screen.
2
Turn the JOG dial button to move the cursor to the
option [W. SELECT]. Then, press the dial button.
3
Turn the JOG dial button to select a desired number
(1 - 8). Then, press the dial button.
4
Turn the JOG dial button to move the cursor to the
option [TITLE:].
5
Press the JOG dial button. This moves the cursor to
the entry area, putting the unit in entry mode.
Error message Remedy
CONFIG NG
NO CARD
(No SD memory card inserted.) Insert an SD memory card.
CONFIG NG
ERROR
(SD memory card cannot be
formatted.) The card may be defective.
Replace the card.
CONFIG NG
WRITE PROTECT
(SD memory card is write-
protected.) Remove the card and cancel
the protect.
CONFIG NG
CANNOT ACCCESS
(SD memory card not
accessible). Example: The SD memory card
is not accessible because it is
being played back.
After the operation in process,
format the card.
CONFIG OK
To write set data on an SD memory card
To select a file number
< SD CARD READ/WRITE >
R.SELECT :1
READ
# W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
To give the selected file a title
< SD CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
# TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
< SD CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
;
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
AJ-HPX2000P(VQT1D27-1)E.book 85 ページ ２００７年７月３０日 月曜日 午後１時３１分