Panasonic AJ-HPX2000 - Manual (Page 170)

170 Menu : Menu Description Tables
‹ Note
When SYSTEM MODE is set to either “1080-59.94i”,
“1080-50i”, “720-59.94P”, or “720-50P” (in HD mode), the
safety zone marker, the safety zone area, and the frame
marker are displayed on the LCD monitor or the SD
viewfinder if “LT-BOX” or “S-CROP” is selected in
DOWNCON MODE.
z The user box can be displayed in any position as a
boxtype cursor.
‹ Note
When SYSTEM MODE item is set to either “1080-59.94i”,
“1080-50i”, “720-59.94P”, or “720-50P” (in HD mode), the
user box is not displayed on the LCD monitor or the SD
viewfinder if “LT-BOX” or “S-CROP” is selected in
DOWNCON MODE.
The ____ in the Adjustable Range column indicates the
preset mode.
VF MARKER
Items/
Data Saved
Adjustable
Range
Remarks
TABLE A
B Select the VF MARKER setting table.
First, select table A or B, then set the
items below for each table.
– C U F R
CENTER
MARK OFF
1
2
3
4 Switch the center mark.
OFF: Do not display center mark.
1:
+ (large)
2: Hollow (large)
3: + (small)
4: Hollow (small)
– C U F R
SAFETY
MARK OFF
1
2 Select the frame type for the safety
zone.
OFF: Do not display frame.
1:
Box
2: Corner frame
– C U F R
SAFETY
AREA 80%
:
90%
:
100%
For setting the size of the safety marker.
It is possible to set the size by units of
1% with a fixed ratio between of width
and height.
– C U F R
FRAME MARK ON
OFF
Set the frame marker to ON or OFF.
– C U F R
FRAME SIG 4:3
13:9
14:9
VISTA Set the frame marker.
Only enabled when REC MODE is set to
16:9.
The VISTA ratio is 16:8.65.
– C U F R
FRAME LVL 0
:
15
Set the level outside the frame marker.
0: Equivalent to signal OFF.
Blanking
status
15: Same brightness as center area. This
setting, however, is disabled if the
FRAME SIG is set to VISTA.
– C U F R
VF USER BOX
Items/
Data Saved
Adjustable
Range
Remarks
USER BOX ON
OFF For setting whether the user box is
displayed in the viewfinder or not.
– C U F R
USER BOX
WIDTH 1
:
13
:
100
For setting the horizontal width of the
user box.
– C U F R
USER BOX
HEIGHT 1
:
13
:
100
For setting the horizontal position of the
user box center.
– C U F R
USER BOX H
POS –50
:
+00
:
+50
For setting the horizontal position of the
user box center.
– C U F R
USER BOX V
POS –50
:
+00
:
+50
For setting the vertical position of the
user box center.
– C U F R
AJ-HPX2000P(VQT1D27-1)E.book 170 ページ ２００７年７月３０日 月曜日 午後１時３１分