Panasonic AJ-HPX2000 - Manual (Page 50)

50 Adjustments and Settings for Recording : Setting the Electronic Shutter
The shutter speed in any shutter mode is set using the
SHUTTER switch.
In SYNCHRO SCAN mode, shutter speed can be switched
easily, using the synchro-scan adjustment switches (+/–)
on the side panel.
Note that the range of selectable shutter speeds may be
pre-defined; whether or not to use the SYNCHRO SCAN
mode may be determined through the <SHUTTER
SPEED> and <SHUTTER SELECT> screens. These
screens are accessible through the menu on the CAM
OPERATION page.
The selected shutter speed is retained even if the unit is
turned off.
1
Press the SHUTTER switch, positioned at [ON],
towards [SEL].
2
Once more, press the SHUTTER switch towards
[SEL]. Repeat this switchover until the desired mode
or speed appears in the viewfinder screen.
If all modes and speeds are available, the display
changes in the following order:
See [ Viewfinder Screen Status Displays ] (page 69).
To place the camera-recorder in SYNCHRO SCAN mode,
follow the steps below.
1
Press the SHUTTER switch positioned at [ON]
towards [SEL], to place the camera-recorder in
SYNCHRO SCAN mode.
2
In the SYNCHRO SCAN mode, it is possible to
change the shutter speed continuously by operating
the SYNCHRO SCAN (+ and –) buttons.
Setting the Shutter Mode and Speed
# < SHUTTER SPEED >
SYNCHRO SCAN :ON
POSITION1 :ON
POSITION2 :ON
POSITION3 :ON
POSITION4 :ON
POSITION5 :ON
POSITION6 :ON
# < SHUTTER SELECT >
POSITION1 SEL :1/100
POSITION2 SEL :1/120
POSITION3 SEL :1/250
POSITION4 SEL :1/500
POSITION5 SEL :1/1000
POSITION6 SEL :1/2000
Viewfinder displays relating to the shutter
SHUTTER switch
POSITION1 POSITION2 POSITION3 POSITION4 POSITION5 POSITION6
NORMAL mode
SYNCHRO
SCAN mode
Placing the Camera-recorder in SYNCHRO SCAN Mode
SHUTTER switch
SYNCHRO SCAN ADJUSTMENT buttons (+/–)
AJ-HPX2000P(VQT1D27-1)E.book 50 ページ ２００７年７月３０日 月曜日 午後１時３１分