Panasonic AJ-HPX2000 - Manual (Page 69)

69 Adjustments and Settings for Recording : Viewfinder Screen Status Displays
A
d
ju
stm
ents and S
e
tti
ngs f
o
r
Rec
o
rdi
n
g
In addition to video images, the viewfinder displays lamps and text that indicate the settings and operating status of the
unit, together with messages, a center marker, a safety zone marker and the camera ID.
The above viewfinder is the AJ-VF20WBP (for further
information on your optional viewfinder model, see the
relevant instruction manual).
1. TALLY/REC (recording) Lamp
This lamp stays illuminated during recording, and
starts blinking if any abnormal action occurs.
For more information, see [Warning System] (page
145).
2. Abnormal Operating Status Warning Lamp
This lamp comes on when the unit is in any of the
abnormal operating statuses specified through the
menu sub-option !LED.
For statuses that activate the lamp, see the options in
the <!LED> screen in [!LED] (page 172).
3. BATT (battery) Lamp
This lamp starts blinking a few minutes before the
battery charge starts to run out, and stays illuminated
after the battery is completely flat. The battery should
be replaced before it is nearly flat, so that operation
will not be interrupted.
For more information, see [Warning System] (page
145).
4. SAVE Lamp
In the normal setting:
The lamp stays on when the SAVE switch is positioned
at [ON] and the output of video and audio is power-
saved.
When the menu option SAVE LED is set to “P2
CARD”:
The lamp starts blinking when the P2 card remaining
free space is getting low.
The menu option SAVE LED can be found in the <VF
INDICATOR2>, which is accessible from the VF page.
5. 50 (50-Mbps recording/playback) Lamp
(In using the SD viewfinder)
This lamp stays illuminated when the unit is set to the
DVCPRO50 (50 Mbps) format, and when playback is
being performed in the DVCPRO50 format.
Note that the lamp is factory-disabled. For more
information, see the relevant section of the menu
option 50M INDICATOR in [VF DISPLAY] (page 169).
The viewfinder can display a screen that allows you to
check the settings and status of the unit.
Each press of the MODE CHECK button switches the
screen as follows:
STATUS screen > !LED screen > FUNCTION screen >
AUDIO screen > No indication
Each screen is displayed for about three seconds. A press
of the MODE CHECK button switches the current screen.
Whether or not to display each screen is specified through
the <MODE CHECK IND> screen, which is accessible
from the VF page.
Viewfinder Screen Status Displays
Lamps in the Viewfinder Screen
1
2 3 4
5
Mode Check Screen Displays (MODE CHECK button function)
# < MODE CHECK IND >
STATUS :ON
! LED :ON
FUNCTION :ON
AUDIO :ON
P.ON IND :ON
AJ-HPX2000P(VQT1D27-1)E.book 69 ページ ２００７年７月３０日 月曜日 午後１時３１分