Panasonic AJ-HPX2000 - Manual (Page 121)

121 Manipulating Clips with Thumbnails : Setting of Clip Meta Data
Ma
ni
pu
la
ting
C
lip
s w
ith
Th
u
m
b
n
a
ils
Select META DATA > USER CLIP NAME from the
thumbnail menu to select the recording method. Two
options are available: TYPE1 and TYPE2.
* The COUNT value is indicated as a four-digit number.
The COUNT value is incremented each time a new clip
is captured if clip metadata has been read in and TYPE2
has been selected as the recording method.
The COUNT value can be reset using the following
procedure.
Select PROPERTY
> DEVICE > META DATA from the
thumbnail menu, then select USER CLIP NAME to
display the menu shown below. Select “COUNT RESET”
with the cursor and press the SET button to reset the
COUNT value to 1.
‹ Note
When a P2 card with a memory capacity of 8 GB or more
is used in camera-recorder and a one-time continuous
recording exceeds the prescribed duration
(DVCPRO HD
and the AVC-Intra 100 (optional): about 5 minutes;
DVCPRO50 and the AVC-Intra 50 (optional): about 10
minutes; DVCPRO or for DV: about 20 minutes)
or when a
one-time recording extends over more than one P2 card,
the recording concerned will automatically be undertaken
as a separate clip. At this time, each clip will be provided
with its own COUNT value.
If the clip thumbnails are displayed as shown in the
example above or their properties are indicated using a P2
device, the thumbnail and COUNT value of clip 1 will be
displayed.
Select META DATA > INITIALIZE from the thumbnail
menu, and press the SET button. Select “YES” when the
confirmation screen is displayed.
‹ Notes
z Japanese or Chinese characters indicated in English or
other characters that cannot be indicated in English will
not display properly; they will be indicated as
¢ .
z The letters which can be input with AJ-HPX2000 are
only the alphanumeric. AJ-HPX2000 cannot input
Japanese and Chinese.
Selecting the USER CLIP NAME recording
method
z TYPE1 (Factory setting
USER CLIP NAME to be
recorded
If clip metadata has been read in Uploaded data
If no clip metadata has been read
in or if the setting for recording
clip metadata has been turned off
Same as GLOBAL CLIP ID
(UMID data)
z TYPE2
USER CLIP NAME to be
recorded
If clip metadata has been read in
Uploaded data + COUNT
value*
If no clip metadata has been read
in or if the setting for recording
clip metadata has been turned off
Same as CLIP NAME
Clear the uploaded metadata
REC start (recording start) REC/PAUSE (recording pause)
Example of recording (DVCPRO HD) a clip on one P2 card:
Example of recording a clip on two P2 cards:
Recording duration = Approx. 7 min.
Clip 1
COUNT value
= 0001 Clip 2
COUNT value
= 0002
5 min. 2 min.
REC start (recording start) REC/PAUSE (recording pause)
Clip 1
COUNT value
= 0003 Clip 2
COUNT value
= 0004
1st card 2nd card
AJ-HPX2000P(VQT1D27-1)E.book 121 ページ ２００７年７月３０日 月曜日 午後１時３１分