Panasonic AJ-HPX2000 - Manual (Page 182)

182 Menu : Menu Description Tables
The ____ in the Adjustable Range column indicates the
preset mode.
MIC/AUDIO2
Items/
Data Saved
Adjustable
Range
Remarks
FRONT MIC
POWER ON
OFF Select the phantom power supply for the
front microphone.
– C U F –
REAR MIC
POWER ON
OFF Select the phantom power supply for the
rear microphone.
When OFF is selected, no phantom
power is supplied even if the REAR
AUDIO CH1 or CH2 switch is set to +48.
– C U F –
MONITOR
SELECT STEREO
MIX When the MONITOR switch is set to ST
(stereo), select the signal format for the
monitor output.
– C U F –
FRONT MIC
LEVEL –40dB
–50dB Select the front microphone input level.
– C U F –
REAR MIC
CH1 LVL –50dB
–60dB Select the rear microphone input level.
– C U F –
REAR MIC
CH2 LVL –50dB
–60dB Select the rear microphone input level.
– C U F –
REAR LINE IN
LVL 0dB
+4dB
–3dB Select the rear line input level.
– C U F –
AUDIO OUT
LVL 0dB
+4dB
–3dB Select the audio output level.
– C U F –
HEADROOM 18dB
20dB Set the headroom (standard level).
– C U F –
WIRELESS
WARN ON
OFF Select whether or not to enable the
alarm to trigger for poor wireless
receiver reception.
– C U F –
TC/UB
Items/
Data Saved
Adjustable
Range
Remarks
TC MODE DF
NDF Set the time code mode.
DF: Drop frame.
NDF: Non drop frame.
‹ Note
When the camera-recorder operates at
50 Hz or in 24P or 24PA mode, the non-
drop frame is always used.
– C U F –
UB MODE USER
TIME
DATE
EXT
TCG
FRM RATE
REGEN Select the user bits mode.
USER: Select UB value set in the LCD
section.
TIME: Select local time (hours,
minutes, seconds).
DATE: Select local date and time (2 last
digits of year, month, date, time).
EXT: When "CAM" , "VIDEO", or
"SDI" is selected in REC
SIGNAL on the SYSTEM MODE
screen, the user bits input to the
TC IN connector are recorded.
When "1394" is selected, the
user bits of signals input to the
DVCPRO/DV connector are
recorded.
If reading fails, USER value is
retained.
TCG: TCG value enters UB.
FRM RATE:
Select the shooting information (e.g.
frame rate) for the camera. For more
information, see [Frame rate
information recorded in user bits
]
(page 58).
When clips recorded in Native mode
are played back, the frame rate
information recorded in users bits in
the VAUX range is output.
REGEN: Read out value stored in the
card and record value
continuously.
‹ Note
When the camera-recorder is in 720P
mode, FRM RATE is always selected.
– C U F –
AJ-HPX2000P(VQT1D27-1)E.book 182 ページ ２００７年７月３０日 月曜日 午後１時３１分