Panasonic AJ-HPX2000 - Manual (Page 118)

118 Manipulating Clips with Thumbnails : Reconnection of Incomplete Clips
Incomplete clips may be generated when clips recorded on
multiple P2 cards (connected clips) are separately copied
to different cards. Reconnection function generates one
clip (the original, connected clip) from incomplete clips.
1
Press the THUMBNAIL button.
The thumbnail screen appears on the LCD monitor.
2
Use the cursor and SET button to select incomplete
clips to reconnect.
Usually, thumbnails of incomplete clips (clips with
marker) are displayed in line.
3
Press the THUMBNAIL MENU button and select
OPERATION
> RE-CONNECTION from the
thumbnail menu.
4
The confirmation window appears. Use the cursor
buttons and SET button to select YES.
‹ Note
indication stays illuminated until all the incomplete clips
that comprise the original clip are reconnected.
Selected clips can be copied to the P2 card or SD memory
card in the desired slot.
1
Press the THUMBNAIL button.
The thumbnail screen appears on the LCD monitor.
2
Use the cursor buttons to move the pointer to the
desired clip and press the SET button.
3
Press the THUMBNAIL MENU button and select
OPERATION
> COPY from the thumbnail menu.
Select Slot 1-5 or SD memory card as the destination.
4
The confirmation window appears. Use the cursor
buttons and SET button to select YES.
‹ Notes
z Do not turn off the power or remove a P2 card while data
is being copied. Doing so may cause the P2 card to fail.
If you should accidentally perform one of the above
operations, defective clips will be generated. Delete
them, and then copy them again.
z When clips are copied to P2 cards, all the information on
the clips is copied. However, when they are copied to the
SD memory card *
1 , video and sound information is not
copied, only thumbnails, clip metadata, icons, Voice
Memo, proxy, and real-time metadata.
z When there is insufficient recording capacity on the
destination, the message “LACK OF REC CAPACITY” is
displayed, and copying will not proceed. When clips to
be copied include some with defects, the message
“CANNOT ACCESS” is displayed, and copying will not
proceed. If selected clips include any that are already
recorded on the destination P2 card, copying will not
proceed.
z To stop copying, press the SET button. Clips currently
being copied to the destination will be deleted.
z When identical clips exist on the destination card, the
“OVERWRITE?” is displayed. Select “YES” or “NO”.
*1 Regarding SD memory cards to be used, see <Cautions
in using SD memory cards> (page 21).
Reconnection of Incomplete Clips
Copying Clips
AJ-HPX2000P(VQT1D27-1)E.book 118 ページ ２００７年７月３０日 月曜日 午後１時３１分