Panasonic AJ-HPX2000 - Manual (Page 99)

99 Preparation Power Supply
P
repa
ra
ti
o
n
1
Remove the battery holder.
2
Mount the NP-1 type battery case on the camera-
recorder.
1 Tighten the mounting screws.
2 Tighten the power contact screws.
3 Insert the upper part of the removed cover in the
direction of the arrow.
4 Align the holes in the bottom part (metal part) of
the cover with the holes in the case, and secure the
cover with the screw.
‹ Note
When mounting the battery holder, take care not to
pinch the connection cord.
When using a V-mount type battery pack
Mount the V-mount adapter plate.
Insert the plate and slide it in the direction of the
arrow.
3
Setting the battery type.
Select the battery type listed under BATTERY
SELECT. Select BATTERY SELECT from the
<BATTERY/P2CARD> screen on the MAIN
OPERATION page.
When using another battery which cannot be selected
using the BATTERY SELECT item setting, select
TYPE A or TYPE B, and set the items that correspond
to the characteristics of the battery.
Please refer to [
BATTERY SETTING2 ] (page 180) for
more information.
‹ Note
For information about the V-mount adapter plate,
please contact the store where you purchased the
camera-recorder.
Using an NP-1 type battery pack
CAUTION:
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of fire or
electric shock do not perform any servicing other than
that contained in the operating instructions unless you
are qualified to do so.
Battery Case (for NP-1 type)
AJ-HPX2000P(VQT1D27-1)E.book 99 ページ ２００７年７月３０日 月曜日 午後１時３１分