Panasonic AJ-HPX2000 User Manual
Page 150
150
Maintenance and Inspections : Warning System
Soft
keyboard
CANNOT CHANGE!
[PERSON] will be entered while the text
memo is not available.
Enter [TEXT] before entering [PERSON].
CANNOT SET!
INVALID VALUE!
The entered value is incorrect.
Change the value.
HDD
USB HOST
MODE
HDD CAPACITY
FULL!
Not enough space left on the hard disk.
There is not enough space on the connected hard
disk. Use a new hard disk or formatted hard disk.
TOO MANY
PARTITIONS!
There are too many partitions.
Hard disks can handle up to 23 partitions. Use a
new hard disk or formatted hard disk.
HDD
DISCONNECTED!
The unit is not connected to a hard disk.
Reconnect the USB cable. If the hard disk does
not operate normally, turn it off and turn it back on
again.
CANNOT FORMAT!
The hard disk cannot be initialized.
Connect another hard disk drive.
TOO MANY
TARGETS!
Multiple devices are connected.
Disconnect devices, turn off the unit and turn it
back on again.
UNKNOWN DEVICE
CONNECTED!
The connected DVD drive is not compatible.
Disconnect devices, turn off the unit and turn it
back on again.
CANNOT ACCESS
TARGET!
An error occurred during hard disk access.
Check hard disk status and connection.
CANNOT
RECOGNIZE
HDD!
The destination target cannot be properly
recognized.
Reboot the hard disk or connect a different hard
disk.
CANNOT ACCESS
CARD!
An error occurred during P2 card access.
Check P2 card.
MISMATCH
COMPONENT!
Copying cannot be made because the
destination card is in the wrong format.
Use a P2 card with appropriate capacity.
P2 CARD IS
UNFORMATTED!
The P2 card is not formatted.
Use a formatted P2 card.
CARD IS EMPTY!
CANNOT COPY!
The P2 selected for copying is empty.
Copying is not performed since the card is empty.
VERIFICATION
FAILED!
The compare check after copying failed.
Copy the data again.
PLEASE FORMAT
P2 CARD!
This warning indicates that data could not be
imported from a hard disk to a P2 card
because the P2 card contained recorded
data.
You cannot copy to a P2 card that contains data.
Format the card on a P2 device and copy again.
Item
Message
Description
Measure
AJ-HPX2000P(VQT1D27-1)E.book 150 ページ ２００７年７月３０日 月曜日 午後１時３１分