National Instruments DIO 6533 - Manual (Page 21)

© National Instruments Corporation 2-1 DIO 6533 User Manual
Chapter
2
Installation and
Configuration
This chapter explains how to install and configure your DIO 6533
device.
Software Installation
Install your software before you install your 6533 device. Refer to the
appropriate release notes indicated below for specific instructions on
the software installation sequence.
If you are using NI-DAQ, refer to your NI-DAQ release notes. Find
the installation section for your operating system and follow the
instructions given there.
If you are using LabVIEW, LabWindows/CVI, or other National
Instruments application software packages, refer to the appropriate
release notes. After you have installed your application software, refer
to your NI-DAQ release notes and follow the instructions given there
for your operating system and application software package.
Hardware Installation
Following are general installation instructions for each device. Consult
your computer or chassis user manual or technical reference manual for
specific instructions about installing new devices in your computer or
chassis.
Installing the PCI-DIO-32HS
You can install a PCI-DIO-32HS in any available 5 V PCI expansion
slot in your computer.
1. Turn off and unplug your computer.
2. Remove the top cover or access port to the expansion slots.
3. Remove the expansion slot cover on the back panel of the
computer.