National Instruments DIO 6533 - Manual (Page 22)

Chapter 2 Installation and Configuration
DIO 6533 User Manual 2-2 © National Instruments Corporation
4. Touch the metal part inside your computer to discharge any static
electricity that might be on your clothes or body.
5. Insert the PCI-DIO-32HS into a 5 V PCI slot. It may be a tight fit, but
do not force the device into place.
6. Screw the mounting bracket of the PCI-DIO-32HS to the back panel
rail of the computer.
7. Visually verify the installation.
8. Replace the top cover of your computer.
9. Plug in and turn on your computer.
Installing the PXI-6533
You can install a PXI-6533 in any available 5 V peripheral slot in your
PXI or CompactPCI chassis.
Note: The PXI-6533 has connections to several reserved lines on the
CompactPCI J2 connector. Before installing a PXI-6533 in a CompactPCI
system that uses J2 connector lines for purposes other than PXI, see
Using
PXI with CompactPCI in Chapter 1, Introduction, of this manual.
1. Turn off and unplug your PXI or CompactPCI chassis.
2. Choose an unused PXI or CompactPCI 5 V peripheral slot. For
maximum performance, install the PXI-6533 in a slot that supports
bus arbitration, or bus-master cards. The PXI-6533 contains
onboard bus-master DMA logic that can operate only in such a slot.
If you choose a slot that does not support bus masters, you will have
to disable the onboard DMA controller using your software. PXI-
compliant chassis must have bus arbitration for all slots.
3. Remove the filler panel for the peripheral slot you have chosen.
4. Touch a metal part on your chassis to discharge any static
electricity that might be on your clothes or body.
5. Insert the PXI-6533 in the selected 5 V slot. Use the injector/ejector
handle to fully inject the device into place.
6. Screw the front panel of the PXI-6533 to the front panel mounting
rails of the PXI or CompactPCI chassis.