National Instruments DIO 6533 - Manual (Page 86)

Chapter 5 Signal Timing
© National Instruments Corporation 5-27 DIO 6533 User Manual
Figure 5-23. Trailing-Edge Mode Output Timing
Burst Mode
Burst mode is a synchronous, or clocked, protocol. The data transmitter
and receiver share a clock signal over the PCLK line.
In every clock cycle, the 6533 device asserts the ACK signal if it is
ready to perform a transfer. If the peripheral device also asserts the REQ
signal, a transfer occurs on the rising clock edge. Either the 6533 device
or the peripheral device can insert wait states into the protocol by
Parameter Description Minimum Maximum
Input Parameters
t
rr*
REQ pulse width 75 —
t
r*r
REQ inactive duration 75 —
t
a*r*
ACK inactive to next REQ inactive 0 —
Output Parameters
t
aa* ACK pulse width 225
1
275
2
t
r*do(1)
REQ inactive to new output data
(with REQ-edge latching) 0 50
t
r*do(2)
REQ inactive to new output data
(with REQ-edge latching disabled) 0 —
t
doa
Output data valid to ACK
(with REQ-edge latching disabled) 25 —
1 t
aa* (min)
= 225 + programmable delay All timing values are in nanoseconds.
2
t
aa*
(max) = 275 + programmable delay
REQ
ACK
Output Data
(REQ-edge latching)
Output Data
(REQ-edge
latching disabled)
tr*r
tr*do(1)
tdoa
taa* ta*r*
trr*
tr*do(2)