Netopia 3300 - Manual (Page 184)

6-18 Firmware User Guide
• If you choose Subnet, you must enter the Remote Member Address and the subnet mask that is the
Remote Member Mask.
Enter the Local Member Address and the Local Member Mask in their respective fields.
• If you choose Range, the next two fields become Remote Member 1st Address and Remote Member
Last Address. You supply these values.
Complete the Local Member 1st Address and Local Member Last Address fields.
• If you choose Host Address, you need only supply the Remote Member Address and the Local Mem-
ber Address; the other fields are hidden.
• Select COMMIT and press Return to add the configuration. This returns you to the IP Profile Parameters
screen. Select COMMIT and press Return in the IP Profile Parameters screen. This returns you to the
Change Connection Profile screen. Select COMMIT and press Return in the Change Connection Profile
screen.
Note:
• Any two IPsec tunnels differ only by the local/remote networks they are intended to reach; they have the
same encr yption policy, which is derived from the base profile.
• The feature is limited to 8 networks per tunnel.
If you return to the IP Profile Parameters screen, two new fields are displayed:
• Display/Change Network allows you to make changes to existing network configurations you have made. If
you select Display/Change Network, a list of your configured networks displays.
IP Profile Parameters
Remote Tunnel Endpoint: 0.0.0.0
Add Network...
Display/Change Network...
Delete Network...
Address Translation Enabled: No
Stateful Inspection Enabled: No
Filter Set... <<None>>
Remove Filter Set
NetBIOS Proxy Enabled No
Advanced IP Profile Options...
COMMIT CANCEL
Define new local/remote member(s)