Netopia 3300 - Manual (Page 57)

System Configuration 3-13
• VLAN Type – Beginning with Firmware Version 8.6.1, LAN or WAN Por t(s) can be enabled on the VLAN. See
“Adding Por t inter faces” on page 3-16 for more information. You can choose a type designation as follows:
port-based: The por ts set up on VLANs for this switch will inser t a default VLAN identifier (VID) into any
non-802.1q-tagged Ethernet packet received, and they will strip out any 802.1q header within a packet
transmitted through the por t with a VID matching the VLAN's VID. The default VID for the VLAN is selected
by the Router.
global: Indicates that the por ts joining this VLAN are par t of a global 802.1q Ethernet VLAN. This VLAN
includes por ts on this Router and may include por ts within other devices throughout the network. The VID
in this case may define the behavior of traffic between all devices on the network having por ts that are
members of this VLAN segment.
• VLAN Name – A descriptive name for the VLAN.
• VLAN Network – From the VLAN Network pop-up menu select None, Primary LAN or, if you have configured
an Additional LAN (ALAN), an Additional LAN. See
“Additional LANs” on page 7-37 .
Note: VLAN changes require a reboot to take effect. See “Restar ting the System” on page 11-8 .
• 802.1x – This option is only available for Router models with VGx technology. Other wise, it does not
appear. If you are configuring a VLAN for a Netopia Router model with VGx technology (wired or wireless),
you can specify a RADIUS ser ver for user authentication by toggling 802.1x to Yes. The default is No.
Adding a RADIUS Profile
• Authentication Profile – If you toggle 802.1x to Yes, this option displays. Select Authentication Profile and
press Return.
If you have RADIUS ser ver profiles already defined, the pop-up menu allows you to select one for use with
this VLAN. If none are defined, the pop-up menu offers the option to configure a RADIUS Profile.
Display/Change VLAN...
+-Name---------------------------IP Address------+
+------------------------------------------------+
| Primary LAN 192.168.1.1 |
| Additional LAN 1 1.1.1.1 |
| Additional LAN 2 0.0.0.0 |
| <None> |1
| |
| |
+------------------------------------------------+
Once a VLAN has been successfully added, configure ports using the
"Add Port Interface" option of the "Display/Change VLAN" menu.