Netopia 3300 - Manual (Page 92)

3-48 Firmware User Guide
Procedure for Default Installation for ICSA firewall certification
of Small/Medium Business Category Module (ADSL Routers)
Note: The following installation procedure outlines steps needed to enable required features to comply with
ICSA firewall cer tification. For more information please go to the following URLs:
http://www.icsalabs.com/icsa/docs/html/communities/firewalls/pdf/4.1/baseline.pdf
http://www.icsalabs.com/icsa/docs/html/communities/firewalls/pdf/4.1/smb.pdf
Install via the Console menu
1. Access the Router through the serial inter face (if available) or telnet to the product from the private (LAN)
side. DHCP ser ver is enabled on LAN by default. See
“Connecting through a Telnet Session” on page 1-4 .
Set up a Connection Profile to configure WAN connectivity: (Follow the Easy Setup instructions in the
Quickstar t Guide, or create a new Connection Profile. See
“Creating a New Connection Profile” on
page 2-9 .)
2. Go to Easy Setup…
3. Set Data Circuit VPI (0-255) to the desired value
4. Set Data Circuit VCI (32-65535) to the desired value
5. Select NEXT SCREEN
6. Choose None as the value for Underlying Encapsulation…
7. Local WAN IP Address and Local WAN IP Mask can be left at 0.0.0.0 if WAN inter face can receive IP
Address from a DHCP ser ver
8. Select NEXT SCREEN
9. Primary Domain Name Server and Secondary Domain Name Server can be left at 0.0.0.0, if dynamic
address is used on WAN
10. Select RESTART DEVICE
Set up administrative interface access restriction
(See “Telnet Tiered Access – Two Password Levels” on page 10-2 for more information.)
1. Go to System Configuration…
2. Select Security… and then Superuser Configuration
3. Type desired username and password. You will be asked to re-enter password. Navigate to 'ADD
SUPERUSER' to add 'Superuser' and restrict access to administrative console.
4. Once 'Superuser' is created, you can add fur ther users, if desired, by going to Add Access Name/Pass-
word...
5. Escape once back to Main Menu