Netopia 3300 - Manual (Page 94)

3-50 Firmware User Guide
Set up NTP
(See “Date and time” on page 3-22 for more information.)
1. NTP is enabled by default.
2. To change NTP Settings, Go to System Configuration and select Date and Time…
3. Set Date and Time parameters, if desired
a. NTP Enabled can be set to On/Off
b. Time Server 1 Host Name/IP Address and Time Server 2 Host Name/IP Address points to the primar y
and secondar y Time Ser vers respectively.
c. Time Zone… can be changed (defaults to Pacific Standard Time)
d. NTP Update Interval can be changed (defaults to one hour)
e. System Date Format can be changed (defaults to MM/DD/YY)
f. System Time Format can be changed (defaults to AM/PM)
g. Escape to the Main Menu and go to Utilities and Diagnostics...
h. Select Restart System... and CONTINUE
Set up Syslog
(See “Logging” on page 3-42 for more information.)
1. Go to System Configuration and select Logging…
2. Under Syslog Parameters,
a. Set Syslog Enabled to Yes
b. Set Hostname or IP Address to the Syslog Ser ver
c. Facility… can be changed (default to Local 0)
d. Set Log Filter Violations to Yes - this will log packets that are dropped by the Router due to violations
e. Set Log Accepted Packets to Yes
f. Set Log Access Attempts to Yes
g. Escape twice to the Main Menu and go to Utilities and Diagnostics...
h. Select Restart System... and CONTINUE
Enable the Stateful Inspection Firewall
See “Stateful Inspection” on page 3-3 for more information.)
1. Go to System Confiuration…, Select Stateful Inspection…
a. UDP no-activity timeout (sec) can be adjusted.
b. TCP no-activity timeout (sec) can be adjusted.
c. Set DoS Detect to Yes
d. Escape twice to get to the Main Menu