Netopia 3300 - Manual (Page 20)

2-4 Firmware User Guide
The Transmit RIP pop-up menu is hidden if NAT is enabled.
Routing Information Protocol (RIP) is needed if there are IP routers on other segments of your Ethernet
network that the Netopia Router needs to recognize. Set to “Both” (the default) Netopia Firmware Version
8.7 will accept information from either RIP v1 or v2 routers. Alternatively, select Receive RIP and select v1,
v2, or v2 MD5 Authentication from the popup menu. With Receive RIP set to “v1,” the Netopia Router’s
Ethernet por t will accept routing information provided by RIP packets from other routers that use the same
subnet mask. Set to “v2,” the Netopia Firmware Version 8.7 will accept routing information provided by RIP
packets from other routers that use different subnet masks.
For more information on v2 MD5 Authentication, see “RIP Options” on page 7-10 .
If you want the Netopia Router to adver tise its routing table to other routers via RIP, select Transmit RIP
and select v1, v2 (broadcast), or v2 (multicast) from the popup menu. With Transmit RIP v1 selected, the
Netopia Firmware Version 8.7 will generate RIP packets only to other RIP v1 routers. With Transmit RIP v2
(broadcast) selected, the Netopia Firmware Version 8.7 will generate RIP packets to all other hosts on the
network. With Transmit RIP v2 (multicast) selected, the Netopia Firmware Version 8.7 will generate RIP
packets only to other routers capable of recognizing RIP v2 packets.
ADSL Line Configuration screen
The ADSL Line Configuration screen is shown below:
1. Select Circuit Type and from the pop-up menu choose the type of circuit to which you will be connecting:
Multimode, T1.413, G.dmt, or G.lite.
2. Select Trellis Coding Enabled. Toggle it to On (the default) or Off.
3. Select Signaling Mode and choose Echo Cancellation or FDM (the default).
4. If you selected Multimode Circuit Type, the Fast Retrain Enabled field appears. Toggle it to On (the default)
or Off.
5. For model 3341 and 3366C ADSL modems, a Wiring Type pop-up menu allows you to choose the type of
copper pair wiring in use at your location. For all other models this option is preset and does not appear.
ADSL Line Configuration
Circuit Type... Multimode
Trellis Coding Enabled: On
Signaling Mode... FDM
Fast Retrain Enabled: On
Wiring Type... AutoSense
Data Link Encapsulation... RFC1483