Setting mbm dip switches, To set mbm dip switches – Nortel Networks BCM200/400 User Manual
Page 123
Chapter 8 Installing a media bay module (MBM)
123
BCM200/400 4.0 Installation and Maintenance Guide
Setting MBM DIP switches
Before you install the MBMs into the BCM system, you must set the DIP switches. Make a note of
these settings either on the chart shown in
or in the Programming Record form.
To set MBM DIP switches
1
Locate the DIP switches on the MBM. See
Figure 71 MBM DIP switches
2
Set the switches to correspond with the settings you chose in the procedure
MBM DIP switch settings” on page 118
.
3
Repeat step 2 for each MBM you want to install.
Note: The GASM and GATM MBMs have a different DIP switch configuration
than shown in
6 5 4 3 2 1
Off
On
Underside of the
MBM
DIP switches
Back of the MBM
1 2 3 4 5 6
On
Off
Rear view of the MBM
MBM is
right-side up