Nortel Networks BCM200/400 - Manual (Page 217)

Chapter 17 Using the Startup Profile to configure parameters 217
BCM200/400 4.0 Installation and Maintenance Guide
The Startup Profile is now loaded on your BCM system.
Startup Profile times and LED sequence
Table 79 provides details about the BCM system boot times and LED sequence using the Startup
Profile to configure system parameters.
Next step
After you have loaded the Startup Profile, you can complete the installation process. Refer to
“Completing the initial installation (optional)” on page 219 for more information.
Note: Make sure the bootup sequence is complete before removing the USB
storage device from the BCM system.
Table 79 Startup Profile times and LED sequence
Duration
(minutes)
Cumulative
time
(minutes)
Power LED Status LED Comments
2 2 Solid green Flashing green
4 6 Solid red off
2 8 Solid green Solid green Initial boot sequence complete
30 38 Solid red Solid green Startup Profile functioning. Duration
varies depending on selected
parameters.
2 40 Solid green Flashing green
Off (error)
Startup Profile is successfully applied.
If there is an error the remaining steps
are not completed.
4 44 Solid red off Duration varies based on selected
parameters.
2 46 Solid green Solid green Reboot complete and system is
functional.
Note: You can safely remove USB
device.
Note 1: If you use Element Manager to configure the parameters, the overall times are similar. Startup Profile enables
you to configure multiple parameters at once, rather than individually using Element Manager.
Note 2: To re-apply the Startup Profile, remove the applied keycode file by returning the system to factory defaults
using the BIT tool.