Nortel Networks BCM200/400 User Manual
Page 289
Chapter 23 Replacing or upgrading a power supply
289
BCM200/400 4.0 Installation and Maintenance Guide
Figure 141 Install the BCM200 MSC guide bracket
7
Connect a P1 power cable to the media bay backplane connector. Tie-wrap the excess cable as
shown in
.
Figure 142 Tie-wrap excess P1 power cable length
8
Connect the hard disk cable to the secondary IDE I/O card connection. Connect the hard disk
cable to the hard disk connector. Connect the power connector to the hard disk (see
). Insert extra connectors under the hard disk.
9
Connect the 20-pin motherboard power cable (P1) and the +12v power cable (P9) to the I/O
card.
Fasten BCM200
MSC guide bracket
mounting screws
BCM200 MSC guide bracket
I/O Card
Hard disk
Fan
MSC
Media bay module backplane
I/O card
Power supply
P1 cable
P1 cable
tie-wrap