Table 23 – Nortel Networks BCM200/400 User Manual
Page 86
86
Chapter 4 Installation overview
N0060612
N0060612
Table 23 BCM system installation overview (Sheet 1 of 2)
Tasks
Description
Link to
Prepare for installation
Verify these requirements:
•
environmental
•
electrical
•
site telephony wiring
“Checking the installation
prerequisites” on page 89
Get required equipment
and tools
Ensure you have these items:
•
basic hardware
•
optional equipment
•
other hardware and tools
“System equipment,
supplies, and tools” on
page 91
Check required
prerequisites
Verify environmental, electrical, and general requirements.
“Checking the installation
prerequisites” on page 89
Install the main unit
Mount the main unit using these options:
•
in an equipment rack with a rack-mount shelf
•
on a wall with a wall-mount bracket
•
on a desktop
“Installing the BCM main
unit” on page 93
Install an expansion unit
(optional)
Mount the expansion unit using the same options as the
main unit:
•
in an equipment rack with a rack-mount shelf
•
on a wall with a wall-mount bracket
•
on a desktop
“Installing the expansion
unit” on page 104
Install a media bay
module (MBM)
Follow these steps to install an MBM:
•
set the MBM DIP switches
•
insert the MBM into the main unit or expansion unit
“Installing a media bay
module (MBM)” on page
107
Connect the cables
Connect the cables between these items:
•
power supply to units
•
lines and extensions to the MBMs
•
data networking hardware
“Connecting the cables”
on page 145
Install telephones and
peripherals
These telephones can be installed:
•
System telephones
•
Emergency telephone
•
IP Phones
•
T7406 cordless system
“Installing telephones and
peripherals” on page 169
Install an ATA2
Perform the steps to install an ATA2:
•
connect the ATA2
•
mount the ATA2
•
test insertion loss measurement
•
configure the ATA2
“Installing the analog
terminal adapter” on page
175
Install optional telephony
equipment
Perform the steps to install:
•
auxiliary ringer
•
external paging system
•
external music source