Ricoh AP306 - Manual (Page 108)

Using the Operation Panel
96
5
❖ 5. Energy Saver
You can select after how many minutes the printer should enter the Energy
Saver mode if no operation is performed. The Energy Saver mode reduces
electric power consumption.
• Off
• 5min
• 15min
• 30min
• 45min
• 60min
Important
❒ After the printer enters Energy Saver mode, it takes some time to warm up
again when print data is received.
❖ 6. Energy Level
You can select the Energy Saver mode level. “Level 1” is the default setting
and saves more power consumption than ”Level 2”.
• Level 1
• Level 2
Note
❒ “Level 1” takes about six minutes to return to the ready condition.
❒ “Level 2” takes about one minute to return to the ready condition.
❖ 7. PDL Sensing
You can set whether or not the printer will automatically switch the printer
language to the appropriate one for the print jobs.
• Auto
• Manual
❖ 8. Transfer
You can select the data transfer speed of the parallel interface. If you are hav-
ing trouble with data transfers, try changing this setting to “Normal”.
• Hi-speed
• Normal
Note
❒ This setting is effective only for "Parallel 1".
❖ 9. Parallel 1
You can select the parallel interface timing setting. Normally it is not neces-
sary to change this setting.
• ACK Inside
• ACK Outside
• STB Down