Ricoh AP306 - Manual (Page 53)

Error & Status Messages
41
4
Reset Paper Tray
Correctly The paper tray is not in-
stalled correctly. Install the paper tray cor-
rectly.
The tray on the paper feed-
ing path was not set cor-
rectly when the printer
received the print job. Install the paper tray cor-
rectly. The printer will re-
start printing
automatically.
Reset Waste T
Bottle Correctly The waste toner bottle is
not installed. Install the waste toner bot-
tle.
⇒
P.78 “Replacing the
Waste Toner Bottle”
Warming Up The printer is preparing for
printing. Wait until the printer is
warmed up.
The printer adjusts itself
regularly to maintain print
quality. (This message
might appear while print-
ing.) It is not an error message.
The printer is working
properly. Just wait a while.
Waste T Full
(on the lower line)
The waste toner bottle is
nearly full. Replace the waste toner
bottle.
⇒
P.78 “Replacing
the Waste Toner Bottle”
Waste Toner is
Full The waste toner bottle is
full. Replace the waste toner
bottle.
⇒
P.78 “Replacing
the Waste Toner Bottle”
A3:Error There is too much data for
the I/O buffer to handle. Check if the interface cable
is inserted into the printer
and the computer securely.
Check if the interface cable
is not damaged or broken.
Increase the size of the I/O
buffer.
⇒
P.83 “Using the
Operation Panel”
A6:Error There is not enough printer
memory to print one or
more of the pages in the
print job. See P.118 “Low Memory”.
AB:Error The printer is unable to
process the data you are
trying to print. Install optional memory
unit to increase the amount
of printer memory.
Reduce the amount of data
being sent to the printer.
Message Description Comments