Ricoh AP306 - Manual (Page 52)

Troubleshooting
40
4
Paper Size Error There is a difference be-
tween the paper size in the
tray and the requested pa-
per size from the computer. After confirming that the
size, feed direction of paper
and the paper size dial in
the tray are set correctly,
open and close the front
cover.
⇒
P.30 “Loading Pa-
per”
Please Wait The printer is warming up
or processing internally. Wait until the printer re-
turns to the ready condi-
tion or processing
internally.
Power Off/On There is a malfunction in
the printer. Turn the printer off and on.
If this does not clear the
problem, contact your sales
or service representative.
Remove Misfeed
From Rear Cover *1
There is a paper misfeed in
the rear cover. Remove the misfed paper.
⇒
P.64 “When the Message
"Remove Misfeed From Rear
Cover" Appears”
Remove Misfeed
Duplex Base Unit *1
There is a paper misfeed in
the duplex tray. Remove the misfed paper.
⇒
P.63 “When the Message
"Remove Misfeed Duplex
Base Unit" Appears”
Remove Misfeed
From Output Tray There is a paper misfeed in
the printer. Remove the misfed paper.
⇒
P.60 “When the Message
"Remove Misfeed From Out-
put Tray" Appears”
Remove Misfeed
From Paper Tray There is a paper misfeed in
the printer. Remove the misfed paper.
⇒
P.58 “When the Message
"Remove Misfeed From Paper
Tray" Appears”
Reset Charger
Correctly
The charger is not set cor-
rectly or the charger clean-
er is not in the correct
position. Set the charger correctly.
⇒
P.80 “Replacing the Charger”
Reset Fusing
Unit Correctly The fusing unit is not in-
stalled in the printer. Contact your sales or ser-
vice representative.
Reset PCU
Correctly The photoconductor unit is
not installed in the printer. Install the photoconductor
unit.
⇒
P.74 “Replacing the
Photoconductor Unit”
Reset Toner
Correctly The toner cartridge is not
installed correctly. Install the cartridge cor-
rectly.
⇒
P.71 “Replacing
Toner Cartridge”
Message Description Comments