Ricoh AP306 - Manual (Page 62)

Troubleshooting
50
4
If you print using the
RICOH-SCRIPT2 printer
driver, printing does not
start or is interrupted. The data is cleared when the Job Timeout period is ex-
ceeded.
❖ Windows 95/98
Set a longer [Job timeout:] period with the [PostScript]
tab of the Printer Properties.
❖ Windows 2000
Set a longer [Job Timeout:] period with the [Device Set-
tings] tab of the Printer Properties.
❖ Windows NT 4.0
Set a longer [Job Timeout:] period with the [Device Set-
tings] tab of the Printer Properties.
❖ Macintosh
Set a longer [Job Timeout] period.
A PostScript error might occur if there is not enough
memory in the machine, or there are errors in the print
data sent to the machine.
• Print the configuration page to check the amount of
available memory.
• If the memory size is full, increasing the memory may
solve this problem. If you still cannot clear the prob-
lem, contact your sales or service representative.
The print job might be reset. Do the following.
• Confirm that you have selected the correct printer
driver. Try printing again.
• Set a longer Wait Timeout.
❖ Windows 95/98
Set a longer [Wait timeout:] period with the [Post-
Script] tab of the Printer Properties.
❖ Windows 2000
Set a longer [Wait Timeout:] period with the [Device
Settings] tab of the Printer Properties.
❖ Windows NT 4.0
Set a longer [Wait Timeout:] period with the [Device
Settings] tab of the Printer Properties.
❖ Macintosh
You can specify a longer "I/O Timeout" period on
the operation panel.
⇒
P.83 “Using the Operation
Panel”
Possible cause Solutions