Ricoh AP306 - Manual (Page 58)

Troubleshooting
46
4
*1 This message appears when you use the duplex printer.
Paper Tray : Not Set Cor-
rectly The paper tray is not in-
stalled correctly. Install the paper tray cor-
rectly.
The tray on the paper feed-
ing path is not set correctly
when the printer receives
the print job. Install the paper tray cor-
rectly. The printer will re-
start printing
automatically.
PCU : Not Set Correctly The photoconductor unit is
not installed in the printer. Install the photoconductor
unit correctly.
⇒
P.74 “Re-
placing the Photoconductor
Unit”
Ready Printer works properly. —
Rear Cover Open *1 The rear cover is open. Close the rear cover.
⇒
the
"Setup Guide" that comes
with the printer
Time to Change Charger It is time to replace the
charger. Replace the charger.
⇒
P.80 “Replacing the Charger”
Time to Change Fusing
Unit It is time to replace the fus-
ing unit. Contact your sales or ser-
vice representative.
Time to Change PCU It is time to replace the pho-
toconductor unit. If printed side gets dirty,
replace the photoconduc-
tor unit.
⇒
P.74 “Replacing
the Photoconductor Unit”
Toner : Not Set Correctly The toner cartridge is not
installed correctly. Install the cartridge cor-
rectly.
⇒
P.71 “Replacing
Toner Cartridge”
Warming Up The printer is preparing for
printing. Wait until the printer is
warmed up.
Waste Toner is Full The waste toner bottle is
full. Replace the waste toner
bottle.
⇒
P.78 “Replacing
the Waste Toner Bottle”
Waste Toner is Nearly Full The waste toner bottle is
nearly full.
Replace the waste toner
bottle.
⇒
P.78 “Replacing
the Waste Toner Bottle”
WasteToner : Not Set Cor-
rectly The waste toner bottle is
not installed correctly. Install the waste toner bot-
tle correctly.
⇒
P.78 “Re-
placing the Waste Toner
Bottle”
xxx Toner is Empty The indicated toner is low
or has run out. Replace the indicated toner
cartridge.
⇒
P.71 “Replacing Toner
Cartridge”
Message Description Comments