Adjusting the image density, P.67 “adjusting the, Image density – Ricoh AP306 User Manual
Page 79: Menu> j ipdl-c menu l, Menu> j maintenance l
Cleaning and Adjusting the Printer
67
4
C
Remove the cleaning brush from
back of the front cover.
D
Insert the cleaning brush into the
back of the light blue guide until
it stops, and then move it left and
right four or five times.
E
Return the cleaning brush to its
original position.
F
Holding the green inset grips of
the photoconductor unit, push the
unit back to its original position.
G
Close the front cover.
Adjusting the Image Density
Changing the image density setting
might cause a deterioration of color
balance. We recommend that you
normally leave the image density at
its factory default setting.
The following procedure describes
how to change the magenta image
density. You can use the same proce-
dure to change the image density for
the other toner colors as well.
Important
❒ Extreme settings may create out-
put that appears dirty.
❒ Image density settings should be
made from the application or the
printer driver whenever possible.
A
Turn on the printer's power
switch.
B
Press {
Menu
}.
The following message appears on
the panel display.
<Menu> j
IPDL-C Menu l
C
Press {T} or {U} to display
"Maintenance", and then press
{
Enter
}.
<Menu> j
Maintenance l
TFWX270E
TFWX280E
TFWS020E
Data In
On Line Reset
Escape
Menu
Media
Power
Enter
Error