Ricoh AP306 - Manual (Page 42)

Paper and Other Media
30
3
Loading Paper
Loading Paper in the Paper
Tray
This section describes instructions for
loading paper in the standard paper
tray and the optional paper tray. If
you want to load paper in the bypass
tray, see P.32 “Loading Paper in the By-
pass Tray”.
Important
❒ Confirm that the setting of the pa-
per size dial matches the paper size
and feed direction of the paper in
the tray. If it does not, misfeeds or
unexpected printing results may
occur.
Reference
For more information about the
size and feed direction of paper
that can be loaded in the tray, see
P.21 “Paper and Other Media Sup-
ported by This Printer”.
A
Slide the paper tray out until it
stops. After that, lift it slightly,
then slide it out of the printer.
Place it on a flat surface.
B
Slide the paper guides to adjust
them to the paper width.
Adjust the paper guides until they
click into position.
Important
❒ Do not touch the friction pad
(A) or paper misfeeds or paper
multi-feeds might occur .
C
Load paper into the tray with the
side to be printed onto face up.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
(TT) inside the tray.
❒ Confirm that paper fits under
the rear guide.
❒ Do not mix different kinds of
paper in the tray.
❒ To avoid paper multi-feeds,
shuffle sheets before setting
them in the tray.
TFWY090E
TFWY101E
A
TFWY110E