Ricoh AP306 User Manual
Page 66
Troubleshooting
54
4
Paper misfeeds occur fre-
quently.
Check the paper size settings. The size specified with
the paper size dial might be different from the actual
paper size. Make the correct dial setting.
Check if the paper tray is set correctly. If not, set it cor-
rectly.
Paper is not loaded correctly in the paper tray. Remove
the paper from the tray and reload it correctly.
Check the paper type settings. The type of paper set
with the printer driver might be different from the ac-
tual paper or media type. Make the correct paper or
media type setting.
You might be using paper not supported by this print-
er. Use the appropriate type of paper.
Multiple pages are fed
through the printer at once.
Clean the friction pad if it is dirty.
The operation panel error
message stays on after re-
moving the misfed paper.
Open the front cover of the printer and then close it.
It takes too much time to
start printing.
The data is so large or complex that it takes time to pro-
cess it. If the Data In indicator is blinking, the data pro-
cessing is being done. Just wait until it resumes.
The Energy Saver mode might be enabled. In the Ener-
gy Saver mode, it takes time for the printer to warm up.
It takes too much time to
complete the print job.
Photographs and other data intensive pages take a
long time for the printer to process, so simply wait
when printing such data.
Changing the following settings may help to speed up
printing.
• IPDL-C printer driver
Set
[Printing Mode]
to
[Fast]
.
Set
[Resolution:]
to
[600 dpi / Fast]
.
• RICOH-SCRIPT2 printer driver
Set
[Gradation]
to
[Fast]
.
The data is so large or complex that it takes time to pro-
cess it. If the Data In indicator is blinking, the data pro-
cessing is being done. Just wait until it resumes.
If "Warming Up" appears on the panel display, the
printer is now warming up. Wait for a while.
Status
Possible causes, Descriptions, and Solutions