Toshiba Tosvert VF-AS1 - Manual (Page 177)

E6581301
F-65
6
6.35 Adjustment parameters
6.35.1 Pulse train output for meters
H : Logic output/pulse output selection (OUT1)
H : Pulse output function selection
H : Selection of number of pulses
H : Constant at the time of filtering
H : FM output filter
• Function
Pulse trains can be sent out through the OUT1-NO output terminals.
To do so, it is necessary to select a pulse output mode and specify the number of pulses.
Set the SW4 to pulse output (PULS).
Ex.) When operations frequencies (0 to 60Hz) are put out by means of 0 to 10kHz
HJ =, H=, H=, H=
The pulse will change between 0 and 10kHz according to the operations frequencies between 0 and 60Hz.
Title Function Adjustment range Default setting
H
Logic output/pulse output selection
(OUT1)  :Logic output
 :Pulse output

H Pulse output function selection
 :Output frequency
 :Frequency command value
 :Output current
 :Input voltage (DC detection)
 :Output voltage
 :Compensated frequency
 :Speed feedback (realtime value)
 :Speed feedback (1-second filter)
 :Torque
 :Torque command
 :Torque current
 :Exiting current
 :PID feedback value
 :Motor overload factor (OL2 data)
 :Inverter overload factor (OL1 data)
 :Regenerative braking resistance
overload factor (OLr data)
 :Regenerative braking resistor load
factor (% ED)
 :Input power
 :Output power
 :Optional AI2 input
 :RR/S4 input
 :VI/II input
 :RX input
 :Optional AI1 input
 :FM output
 :AM output
 :Fixed output 1
 :Communication data output
 :Fixed output 2
 :Fixed output 3
 :Cumulative input power
 :Cumulative output power
 :My function monitor 1
 :My function monitor 2
 :My function monitor 3
 :My function monitor 4

H Selection of number of pulses  .~.kHz 
H Constant at the time of filtering  msec, msec~msec 
H FM output filter
 :No filter
 :Filter approx. 10ms
 :Filter approx. 15ms
 :Filter approx. 30ms
 :Filter approx. 60ms

Note: The pulse length is fixed. Therefore, the duty is variable.