Toshiba Tosvert VF-AS1 - Manual (Page 189)

E6581301
F-77
6
Title Function Adjustment range Default setting
H Frequency point selection
 :Disabled
 :2-wire RS485
 :4-wire RS485
 :Communication add option

H Point 1 setting  ~% 
H Point 1 frequency  ~HJHz 
H Point 2 setting  ~% 
H Point 2 frequency  ~HJHz
Inverter with a model
number ending with
-WN:  
-WP:  
H Block write data 1
 :Deselect
 :Command information 1
 :Command information 2
 :Frequency command
 :Terminal board output data
 :Communication analog output

H Block write data 2 Ditto 
H Block read data 1
 :Deselect
 :Status information
 :Output frequency
 :Output current
 :Output voltage
 :Alarm information
 :PID feedback value
 :Input terminal board monitor
 :Output terminal board monitor
 :VI/II terminal board monitor
 :RR/S4 terminal board monitor
 :RX terminal board monitor
 :Input voltage (DC detection)
 :Speed feedback frequency
 :Torque
 :MY monitor 1
 :MY monitor 2
 :MY monitor 3
 :MY monitor 4
 :Free notes

H Block read data 2 Ditto 
H Block read data 3 Ditto 
H Block read data 4 Ditto 
H Block read data 5 Ditto 
H Free notes  ~HHHH 
* : No action .... No action is taken even if a timeout occurs.
Alarm ......... An alarm goes off if a timeout occurs.
The message “V” blinks at the left end of the operation panel.
Trip ............. The inverter trips when a communication time-over occurs.
The message “GTT” blinks on the operation panel.
Note:Changes to the parameters H, H and H do not take effect until the power is turned off and
then on again.