Toshiba Tosvert VF-AS1 - Manual (Page 193)

E6581301
F-81
6
Title Function Adjustment range Default setting
H Block read data 1
 :Deselect
 :Status information
 :Output frequency
 :Output current
 :Output voltage
 :Alarm information
 :PID feedback value
 :Input terminal board monitor
 :Output terminal board monitor
 :VI/II terminal board monitor
 :RR/S4 terminal board monitor
 :RX terminal board monitor
 :Input voltage (DC detection)
 :Speed feedback frequency
 :Torque
 :MY monitor 1
 :MY monitor 2
 :MY monitor 3
 :MY monitor 4
 :Free notes

H Block read data 2 Ditto 
H Block read data 3 Ditto 
H Block read data 4 Ditto 
H Block read data 5 Ditto 
H Free notes  ~HHHH 
* : No action .... No action is taken even if a timeout occurs.
Alarm ......... An alarm goes off if a timeout occurs.
The message “V” blinks at the left end of the operation panel.
Trip ............. The inverter trips when a communication time-over occurs.
The message “GTT” blinks on the operation panel.
Note:Changes to the parameters H, Hand H do not take effect until the power is turned off and
then on again.
6.38.2 Open network option
H ~ H : Communication option settings 1 to 7
H ~ H : Communication option settings 8 to 13
H : Disconnection detection extended time
H : Inverter operation at disconnection
H : Preset speed operation selection
H , H : Selection of monitoring
⇒ For details, refer to Instruction Manual (E6581280, E6581342) specified in Section 6.41.
6.39 My function
H : Input function target 11~ H : My function selection
⇒ For details, refer to Instruction Manual (E6581335) specified in Section 6.41.