Toshiba Tosvert VF-AS1 - Manual (Page 204)

E6581301
G-10
7
7.3 Setup of external speed command (analog signal)
Function of analog input terminals can be selected from four functions (external potentiometer, 0 to 10Vdc, 4 (0) to
20mAdc, -10 to +10Vdc). The selective function of analog input terminals gives system design flexibility.
⇒ Refer to Section 6.28 for fine adjustment of analog setting signal and output frequency.
[Control terminal board]
■ Setting of analog input terminal functions
Terminal
symbol
Title Function Adjustment range
Default
setting
Setting
value
- H Frequency priority selection
 :HOQF/H terminal
switching (input terminal
function selection,

)
 :HOQF/H
frequency switching
(switch by H)

H VI/II input point 1 setting  ~% 
H VI/II input point 1 frequency  ~HJ Hz 
H VI/II input point 2 setting  ~% 
VI/II
CKH VI/II input point 2 frequency  ~HJ Hz *1
- H Frequency setting mode selection 2 Same as HOQF (~) 
- H Speed command priority switching frequency  ~HJ 
All H Analog input filter  (No filter)~ (Max. filter) 
H RR/S4 input point 1 setting  ~% 
H RR/S4 input point 1 frequency  ~HJ Hz 
H RR/S4 input point 2 setting  ~% 
RR/S4
CXH RR/S4 input point 2 frequency  ~HJ Hz *1
H RX input point 1 setting -~% 
H RX input point 1 frequency  ~HJ Hz 
H RX input point 2 setting -~% 
RX
H RX input point 2 frequency  ~HJ Hz *1
H
~H
AI1, AI2 input point setting
For details, see Instruction Manual
(E6581341) specified in Section 6.41.
Option
H
~H
RP/high speed pulse input point setting
For details, see Instruction Manual
(E6581319) specified in Section 6.41.
*1: Inverter with a model number ending with -WN: 60.0 -WP: 50.0
Note 1: Input terminals of AI1 and AI2 are at expansion TB option unit.
Note 2: Input terminals of RP/high speed pulse is at PG feedback device option unit.