Vax M-9000 - Manual (Page 46)

46
Set the ducker function ( p. 26 ) to ON or OFF.
• ON: Activates the ducker function.
• OFF: The ducker function does not work.
D U C K E R O F F
(A24) Ducker ON/OFF setting (when the AN-001T is not used)
Set how much the input signal for the channel given lower priority than that of the currently set input channel
should be attenuated.
The minus figures in dB represent amount to attenuate input signals. The larger the minus figures, the larger
the amount of attenuation. Selecting "OFF" sets the attenuation to infinity, while selecting "0" sets to no
attenuation, permitting all input signals to be mixed and output.
OFF (default), –50, –40, –30, –20, –10, 0 dB Setting Range
D U C K E R D E P T H O F F
(When the ducker function is set to ON)
(A26) Ducker depth setting (when the AN-001T is not used)
(A27) Output assignment and level settings (when the AN-001T is not used)
I N 1 O U T 1 0
Set which output channel in what level an audio source at the currently selected input channel should be
output to.
Select the output channel from Channel 1 to 8 (maximum) with the Left or Right shift key, and set the output
level with the Parameter setting knob. By repeating this procedure, 2 or more output channels can be
assigned.
Pressing the output channel ON/OFF key alternately switches the level between "0 dB" and "–
∞."
OUT1 – 2, Max. 8 when T-001Ts are used (default: OUT1)
0 dB (default)
–
∞, –70.0 dB to +10.0 dB, 1 dB steps
Setting Range Output Channel
Assigned Output Level
ON, OFF (default) Setting Range
Set the priority level as follows: Priority 1 or 2 for the input channel on which the D-001T is used, and only
Priority 2 for the input channel on which the input module other than the D-001T is used. Priority 1 is higher
than Priority 2 in priority level.
The ducker function does not work among the input channels with the same priority level.
The function does not work either unless the relevant input channels are all set for the ducker function,
permitting all the input signals to be mixed and output.
The input channel with the paging function has precedence over PRIORITY 1.
When the D-001T is used: PRIORITY 1 (default), PRIORITY 2
When other input module is used: PRIORITY 2 (default)
Setting Range
D U C K E R P R I O R I T Y 1
(When the ducker function is set to ON)
(A25) Ducker priority level setting (when the AN-001T is not used)