Utility setting items, P. 56-c3, Each time the number – Vax M-9000 User Manual
Page 56: P. 56-c1), P. 56-c2), P. 56-c3)
56
10.5.2. Utility setting items
Unless otherwise specified, use the Parameter setting knob for each parameter selection.
S T E R E O L I N K
O U T 1 2
(C1) Stereo link setting
P A G I N G
O F F
(C2) Paging ON/OFF setting
N O M A T T E N U A T E
0
(C3) NOM attenuation setting
Set the paging function to ON or OFF.
• ON: Enables the paging function.
• OFF: Paging function does not work.
When set to ON, refer to
for the paging setting flow chart.
Set the amount of NOM (Number of Open Microphones) attenuation.
The NOM attenuation function automatically reduces an output gain to prevent the entire volume from being
excessively raised due to open microphones.
When the value to be set here is A and the number of open microphones is N, the attenuation gain is given by
the following equation:
Attenuation gain = A x log
10
N
This function is valid only for the D-001T's input channels having the NOM attenuation function.
Set a paired input or output channel as stereo input or stereo output so that both channels can be
synchronously operated. Select a channel pair with the Parameter setting knob, and determine it with the
Enter key. Pressing the Enter key again cancels this setting. By repeating this procedure, up to 8 channels (4
pairs) each for input and output can be set when the number of input and output channels is maximum.
When the paired channel is stereo-linked, an equal mark "=" appears between both channel numbers.
Parameter settings for the stereo-linked channels synchronize. Parameters that can be synchronized are as
follows:
Input channel:
Channel gain, Channel ON/OFF, and D-001T's parameters (where Phantom power and
NOM attenuation function are fixed to OFF)
Output channel: Channel gain, Channel ON/OFF, Channel name, Bass, Treble, Loudness compensation,
EQ, HPF, LPF, Compressor, Delay, and T-001T's parameters (where Phantom power
and NOM attenuation function are fixed to OFF)
Default: No channel is stereo-linked.
Note
The ZP-001T channel cannot be stereo-linked.
Up to 8 channels (4 pairs) each for input and output can be set as follows when the
number of input and output channels is maximum:
OUT 1 – 2, OUT 3 – 4, OUT 5 – 6, OUT 7 – 8, IN 1 – 2, IN 3 – 4, IN 5 – 6, and IN 7 – 8
Setting Range
ON, OFF (default)
Setting Range
0 – 20 (default: 0)
Setting Range