Vax M-9000 - Manual (Page 84)

84
(H5) Scene memory erasure (when ERASE is set)
E R A S E 0 1
Erase the saved Scene memory.
Pressing the Enter key erases the Scene memory in the designated memory bank number.
To cancel erasure execution, press the Escape/Back key.
After erasure completion, the unit setting is restored to the factory default setting.
(H6) Scene memory bank number to be recalled at power-on (when P-ON is set)
P O W E R O N L A S T S T A T E
Set either the Scene memory bank number to be automatically recalled at power-on, or "LASTSTATE."
When LASTSTATE is selected, the unit returns to the state just before power-off when turned on.
Even if the AC power supply is cut off during setting, the parameters that have been set so far are all saved.
When the power returns, the unit is powered up to the state just before power-off.
When a Scene number is selected, if the AC power supply is cut off during setting, the parameters that have
been set so far are all cancelled. When the power returns, the unit is powered up to the state that was saved
into the set Scene memory bank number.
(H4) Scene memory name setting (when SAVE is set)
B A N K 0 1 N A M E = _ _ _ _ _ _ _
Give a name to the Scene memory.
The flashing portion is the cursor position for entering Scene memory name characters.
Select a character from the alphanumeric character list by rotating the Parameter setting knob, then move the
cursor with the Right shift key.
Entering a new name overwrites the existing name, if there is.
To delete the character, select " _ " (underscore) with the Parameter setting knob. A space character cannot
be entered.
Up to 7 characters can be used to set the name.
7 characters (default: _ _ _ _ _ _ _) Setting Range
01 – 32 (default: 01) Setting Range
LASTSTATE (default), 01 – 32 Setting Range