Vax M-9000 - Manual (Page 62)

62
10.6. Paging Setting
10.6.1. Paging function
Paging function enables paging broadcasts from the outside to be made to the closed space(s) where the
9000 Series amplifier is used.
To use the paging function, perform the paging function setting as well as the audio input and output
parameter settings.
In the audio input parameter setting, be sure to set the Ducker function to ON. Doing otherwise causes the
paging calls to mix with input signal being broadcast.
When the ZP-001T is used, paging calls are output at the output channels selected by telephone dial
operation.
When an input module other than ZP-001T is used, paging calls can be made to up to 4 paging zones to
which up to 8 output channels can be assigned.
Output channels can be redundantly assigned to each zone.
Paging prohibited channels can also be set.
When paging calls are initiated using an input module other than the ZP-001T, if an output channel is set as a
paging prohibited channel, no paging calls are made to all of the paging zones to which the output channel is
assigned.
When paging calls are initiated using the ZP-001T, set all the output channels to be paging-disabled for
paging prohibition.
Be sure to set the paging input channel to ON. Otherwise, paging calls cannot be performed.