Philips HR7724 - Manual (Page 4)

Automatic cut-out
Read these instructions carefully before you start using the
appliance
To prevent damage due to overheating, your appliance has been
equipped with an automatic cut-out system. In case of overheating, this
system will automatically cut off the power supply to the appliance.
If you follow the instructions below, you can switch on the appliance
again after you have let it cool down for 15 minutes.
If your appliance suddenly stops running:
- Pull the mains plug out of the socket
- Set the switch to position O
- Let the appliance cool down for 15 minutes
- Put the mains plug back in the socket
- Switch on the appliance again.
Please contact your Philips dealer or an authorised Philips service centre
if the automatic cut-out system is activated time and again.
Important
• Read the directions for use and look at the illustrations before you
start using the appliance.
• Remove the protective cover from the blade each time you use it.
• Be very careful when you pick up the blade, the knife of the
blender and the slicing/grating disc. They are very sharp!
• Thoroughly clean the parts that will come into contact with food
before you use the appliance for the first time.
• Place the lid on the bowl in the right position. The built-in safety
lock will now be deblocked and you will be able to turn on the
appliance.
• Note that if both the blender and the bowl have been correctly
mounted, only the blender will function.
• Never let the appliance run unattended.
• Never let children run the appliance.
• When you are mixing or blending liquids, do not exceed the
maximum content indicated on the bowl or the blender (top line of
the graduation).
• Do not exceed the maximum amounts and processing times
indicated in the table.
• Wait until moving parts have stopped running before you remove
the lid of the appliance.
• Never put your fingers or objects (e.g. a spatula) in the chute while
the appliance is running. Only the pusher is to be used for this
purpose.
• Never put your fingers or objects (e.g. a spatula) in the blender
unless you have unplugged the appliance first.
• Never immerse the motor unit in water or any other liquid. Do not
rinse it either.
• Unplug the appliance after use.
• If the mains cord of this appliance is damaged, it must always be
replaced by Philips or a service centre authorised by Philips, in
order to avoid hazardous situations.
• Keep these directions for use for future reference.
4